HiTHERM's HT-300 Series
HiTHERM's HT-300 Series is a nominal 2 lb/cu. ft. closed cell rigid polyisocyanurate foam insulation line that covers a wide range of applications and densities within the temperature range of -297°F to +300°F, with intermittent capabilities to +350°F for short periods of time. These application include, but are not limited to:
- Commercial Chilled Water
- Use in Air Plenums
- Central Chiller Plants
- Institutional Applications
- Refrigeration/Cryogenic
- Low Pressure Steam and etc.
 |
HT-300 PolyisoHT-300 is a nominal 2 lb/cu.ft polyisocyanurate foam (PIR) that is supplied to a wide-ranging network of fabricators in the form of bunstock. HT-300 is our flagship product and offers great thermal properties in addition to great performance for chiller plants, refrigeration/cryogenic, use in air plenums and a variety of other applications. Some of these excellent properties are:
|
|
HT-303 PolyisoHT-303 is a nominal 3lb/cu. ft., closed cell rigid polyiso (PIR) foam. HT-303 boasts exceptional characteristics at continuous service temperatures of -297°F to +300°F. HT-303 can be used in a variety of applications where higher compressive strengths are necessary.
|
|
|
HT-304 PolyisoHT-304 is a nominal 4lb/cu. ft., closed cell rigid polyiso (PIR) foam. HT-304 boasts exceptional characteristics at continuous service temperatures of -297°F to +300°F. HT-304 can be used in a variety of applications where higher compressive strengths are necessary than the HT-303 can provide.
|
|
|
HT-306 PolyisoHT-306 is a nominal 6lb/cu. ft., closed cell rigid polyiso (PIR) foam. HT-306 boasts exceptional characteristics at continuous service temperatures of -297°F to +300°F. HT-306 can be used in a variety of applications where higher compressive strengths are necessary.
|
 |
HT-300 Pipe Support SystemAlso available with the HT-300 Insulation System is the engineered pipe support. This support can be engineered to withstand pressures up to 1,695psi using the 2# density HT-300 insulation. This allows for continuous use of a single insulation for an entire project and eliminates the "thermal shorts" that can be caused by cal-sil, cellular glass and other expensive products with much higher k-factors (lower R-values). >Photo courtesy of a HiTHERM fabricator. Contact your HiTHERM representative for information. |